How do you reset a Suunto dive computer?

How do I turn on my Suunto dive computer?

Press the SMART (MODE) button

To activate the dive computer. To change from the Surface Mode to the menu based modes.

Are Suunto dive computers too conservative?

yle Scuba Instructor

Suuntos would always give the less time than just about every other computer. You will likely get some responses here that give you more detail about the algorithms used by different computers, but what it comes down to is… yes, Suuntos are conservative.

How do I disable Zoop?

Suunto Zoop Novo display turns off after 30 minutes of inactivity to save battery time. To turn the display back on, press any button.

What is the no decompression limit?

The no decompression limit (NDL) is the maximum allowable dive time that you can remain at a specific depth and ascend directly to the surface without requiring staged decompression stops on the way up. Remember the higher the partial pressure of nitrogen (ppN2), the shorter the dive time (NDL).

What is conservatism in diving?

Generally speaking, conservative means safer. In practice it means that a dive at a given depth is shorter due to the decompression obligation (the no decompression time is short). … For recreational divers, a conservative model means less time in the water in order to avoid decompression requirements.

IT IS INTERESTING:  How do you store water skis?

When using ANX compatible dive computer to manage oxygen what should you do?

To use an EANx compatible dive computer to remain within accepted oxygen exposure limits:

  1. set your maximum oxygen partial pressure to 1.4.
  2. set your specific dive blend.
  3. activate scroll mode that show your no stop limits.

How do I charge my Suunto dive computer?

For charging, use a USB port of 5Vdc, 0.5A as a power source. If the battery is very low, the display remains dark while charging until the battery has reached an adequate charge level. NOTE: You cannot use buttons on your Suunto D5 when the USB cable is connected to a computer.

How do I reset my Suunto Zoop dive computer?

The memory of a diving computer cannot unfortunately be reset as this is a circle memory. The diving computer will start automatically overwriting the oldest dives when the memory capacity is exceeded. The maximum depth in the history memory can be zeroed but this can be done only in the Dive Manager software.

How do you use Zoop?

To get started:

  1. Wake up the device by keeping any button pressed until the display turns on.
  2. Keep DOWN pressed to enter General Settings.
  3. Set time. See Time.
  4. Set date. See Date.
  5. Set units. See Units.
  6. Press MODE to exit settings.

How do I setup my Suunto Zoop Novo to Nitrox?

How to change the Nitrox setting:

  1. Press the ‘mode’ button.
  2. Press the ‘plan’ button until ‘set’ is displayed on the screen.
  3. Press the ‘mode’ button.
  4. To cycle through this menu, press ‘plan’ four times until ‘model’ is displayed on the screen.
  5. Press the ‘mode’ button. …
  6. Press ‘plan’ until ‘nitrox’ is displayed on the screen.
IT IS INTERESTING:  When did surf rock begin?