How do you clean a wakeboard?
WAKEBOARDS. Cleaning & Storage: Clean with fresh water and leave out of cover to dry in a shaded place. Do not put any protective coatings (eg: polishes or armor-all) on binding rubbers or bottom of board leave as purchased. If storing in a cover make sure board & boots have been dried out in the shade first.
What to do once you get up on a wakeboard?
Staying Up on the Wakeboard
Once you’re up, you should keep your knees slightly bent instead of making them straight. By keeping your knees bent, you will absorb impact from the water. Your elbows should stay straight as you hold onto the tow rope. The tow rope should be held in front of your hips.
Is it hard to get up on a wakeboard?
Getting up on a wakeboard can be challenging because there are a lot of things that need to occur with the right time and sequence. But the main issue is that learners typically try to pull themselves out of the water instead of letting the boat pull them.
Is it harder to water ski or wakeboard?
Wakeboarding is much harder and more complicated than waterskiing, but incredibly fulfilling once you get the hang of it! Plus, after you know how to waterski, then wakeboarding will be easier to learn. … Wakeboarding also has one thick shorter board for wakeboarding.
Where should your weight be when wakeboarding?
Correct Body Position
Your weight should be centered between both feet, and your knees should be slightly bent. Your shoulders and hips need to be lined up with the board. While holding the tow rope, your elbows should be straight and the handle should be in front of your hips between your knees.
Do you put both fins on a wakeboard?
While fins are not required, without them the board can slide pretty freely. Riding this style of board without fins is more for advanced riders, who have a good idea of how putting a wakeboard ‘on edge’ works. Fin holes on these boards are often in the middle on each end of the board for a single fin.
What angle should my wakeboard bindings be?
Beginner – Recreational Stance
Back Binding – Zero degrees at the backmost position on the board. Front Binding – Pointing towards the front of the board at a 15- to 27-degree angle (two to three holes from the center of the binding plate). Place at a natural distance from the rear binding.